Press DOWN to SAFETY TIMER - Adjustable between 20 and 300 minutes. An alarm will sound during charging after selected time interval during charging has elapsed. Set the time for about 30% longer than it should take your pack to charge.

Press DOWN to TCS CAPAClTY - For LiPo and Lilon battery types Terminal Capacity Selection is available from 50% to 100% of  pack capacity. During the charge, the EOS 0610i DUOII will continually estimate capacity in the pack, and either terminate the charge or sound a signal tone (and continue charging) when your selected TCS percentage is reached, depending on the value for you set for TCS END ACTION. See end of manual for more details on TCS.

Press DOWN to TCS END ACTION - Values are CONTINUE and STOP. CONTINUE is the default. In this case, when TCS% is reached for settings 50% to 95%, the charger will "beep" 10 times, but continue charging to 100% until stopped. If TCS  ACTION is set to STOP, the charger will stop charging at that TCS setting and - if balancing is complete - then give COMPLETE (END) Buzzer according to you buzzer settings. (or continue till balanced, then give End buzzer).

Press DOWN to DSCH CURRENT - If you'll be discharging, you'll set the discharge current here. Note that depending on the voltage of the pack, the current you set may not be obtainable if the total Volts multiplied by Current (Al exceeds 50w.

Press DOWN to DSCH VOLTAGE per cell - Lithium types should only be discharged for storage, so we recommend that you use STORE MODE for that. Otherwise, you need to be sure of the V/cell setting yourself, according to your battery type. Over-discharge can damage packs.

Pressing DOWN for a last time returns you to the 'Memory Select' screen.

At this point, see flowchart (7) LiIo / LiPo / Al23 BATTERY START. Holding the ENTER key pressed down for two seconds or more will start the CHARGE, STORE, or DISCHARGE process (select with UP/DOWN Keys) for LiPo, Lilon, and A123 types, no matter where in the MEMORY (CHARGE) screens you may be. Additionally- if balancer circuit is connected - SYNC MODE is available via ENTER (short push) and UP/DOWN arrow keys.

With "CHARGE START SOLO MODE" selected, hold down ENTER for 2 seconds. Hold down ENTER again, the charger will then read **BATTERY CHECK** and then ask you to confirm the number of cells in your battery pack. Press ENTER (short press) for a final time to start charging. (if balancer is connected, a 10-second countdown occurs, then auto start).

Note: If the Lithium-based pack is NOT connected to the balancer port, the Charger will read NO BALANCER. We strongly recommend using the balancer at ALL times.

Holding down ENTER (2 seconds) at any time while charging a battery will then STOP charging (or discharging, etc ... ).

During Charging/Discharging/Store , Pressing the MODE button will scroll you through the MEMORY, BALANCER and QUICK VIEW Data screens. (see chart (9) OPERATION and FINISH DISPLAY)

* MEMORY - Short-press UP/DOWN buttons

you can press ENTER and UP/DOWN to change charge current if desired. You can also LONG-press (2-seconds) UP button to see each screen presented in turn at two-second intervals.

* BALANCER - UP/DOWN buttons to see detailed information on cell balancing, and individual cell voltages

* QUICK VIEW - Shows the following useful info on a single screen:

Press the MODE button until you reach the DATA VIEW screen. (see chart (3) Data View Display)

Use the UP or DOWN key to scroll through the various information presented:

*INPUT - Current input voltage from the power supply

*OUTPUT - The output voltage of charger while charging, or pack voltage of the battery while connected but not charging

*BAT. RES - The internal resistance (IR) of the battery pack in mQ.

*TEMP and PEAK TEMP - Current Temp, and Peak Temp recorded during the charge (requires optional temp sensor)